Terminator 2 JD 
37
Using the  old playfield as a  template I will check the accuracy of the previuosly drilled and  dimpled NOS playfield that was supplied.
37
Using the old playfield as a template I will check the accuracy of the previuosly drilled and dimpled NOS playfield that was supplied.
Viewed: 191 times.

38
Old is over new.
38
Old is over new.
Viewed: 206 times.

39
I found  quite a few  holes still missing  so these will be added.I also see  holes that will need to be enlarged.The ones added are  pretty obvious.
39
I found quite a few holes still missing so these will be added.I also see holes that will need to be enlarged.The ones added are pretty obvious.
Viewed: 183 times.

40
40
Viewed: 158 times.

41
The  flipper  alignment  holes were not  there so those have been added.Roll pins  go inside them.
41
The flipper alignment holes were not there so those have been added.Roll pins go inside them.
Viewed: 182 times.

42
The old playfield shows the  correct drilling in the  jet bumper area.
42
The old playfield shows the correct drilling in the jet bumper area.
Viewed: 187 times.

43
Notice the new playfield is not properly  drilled in this area.The  holes should be  countersunk so the heads of the jet bumper nails are  below the surface of the  wafer when installed. The holes are going to be a little  tougher to   drill properly now because   centering is  hard  when the  hole is already made  but I will  work on making this correction next.
43
Notice the new playfield is not properly drilled in this area.The holes should be countersunk so the heads of the jet bumper nails are below the surface of the wafer when installed. The holes are going to be a little tougher to drill properly now because centering is hard when the hole is already made but I will work on making this correction next.
Viewed: 178 times.

44
Cabinet is  almost emptied.
44
Cabinet is almost emptied.
Viewed: 196 times.

45
45
Viewed: 194 times.

Powered by Gallery v1 RSS