41
Power box is ready to install.
|
42
The hologram projector will be refinished and upgraded.
|
43
Parts are refinished.More powerful lighting will be used.
|
44
Projector restored.
|
45
The cabinet wiring and components are now in place.
|
46
The pivots were upgraded to the newer style with the full metal plate in place of the two washers.This give a more stable t
|
47
The backboard lighing was tied into the coin door lighting so they are all now part of the cabinet lighting circuit.
|
48
|
49
The old dmd panle will be rebuilt and swapped over to the new tail light modded one.
|
50
The grilles had to be drilled out for the lighting to come through in some places.
|
51
The game will benefit from a new DMD.The old one was burned in.
|
52
DMD panel is rebuilt.
|
53
Lamp and dmd panel are in place.
|
54
the replacement playfield has been sanded polished and prepped for rebuild.
|
55
New T nuts are installed.
|
56
Through parts and ball guides are installed.This game has the more rare metal siderail stiffeners.
|
57
Teal conversion is being done.
|
58
I use black pop bumper wafers on CFTBL because I like the match it gives to the outer ring and playfield art accents and b
|
59
Ready to flip and begin rewiring the underside.
|
60
Underside ready.
|
61
Switch harness and rebuilt flippers are in place.
|
62
Lamp harness,boards and coils are installed.All that is left in terms of wiring is the coil harness.
|
63
Coil harness is in place and soldered in.
|
64
Pre -wiring of underside complete.
|
65
Ready to go back into the cabinet.
|
66
Playfield is back in place.
|
67
Going with more of a drive in type color theme on this one.
|
68
I like the black bat and white rubber near the car it gives the impression of whitewall tires even though the flipper do n
|
69
Sticking with the black and whie theme I am using the white color sleeves from Cliffy.There are a lot of white accents on t
|
70
Modded DMD panel is up and running along with the lighted backboard.The one blinker installed is behind the creature.
|
71
Powered up for testing.
|
72
Plastics and ramps are being put in place.The swapping of these ramps can be ver slow.All switch wiring of the ramps is
|
73
Stainless flaps were insalled on the new ramps as well.
|
74
|
75
Almost there.the more that goes on the more the scheme comes together.
|
76
This is my donor coin door.It is the correct style for this game but does have a backle in it below the slots.
|
77
I will install an NOS center and new slot faces after I clean and restore the other parts.
|
78
"New" door is built.
|
79
New door installed.
|
80
Game is complete less one clear plastic on the bowl and the translite.Other than that just detail work and clean up.
|