81
Boards seem to function properly so they are now installed in the new head.
|
82
Cleaning and polishing the hardware as it moves over will be next.
|
83
Lamp panel needs to be refinished and rebuilt.
|
84
Torn down.
|
85
Refinished.
|
86
Rebuilt with polished parts,Pinscore displays and all new bulbs.Fit and installed in the head.
|
87
Lower is ready to braid and rebuild.
|
88
|
89
There is no chocking.That will have to be cut fit and installed next.
|
90
The original chocking that needs to be duplicated.Left side.
|
91
Original chocking on the right.
|
92
Head is back on lower,new siderails are installed.
|
93
The material the chocking will be cut from.
|
94
Right side chocking is now made and installed on the right.I used just a little glue and screws to secure it since this i
|
95
Left side chocking now installed.
|
96
Next up is restoring th transformer panel.
|
97
Takes a few hours to do one of these with the bulk of the time spent removing the rust and polishing it.It isn't the type
|
98
Rear glass trim installed along with a new speaker and other hardware.
|
99
Plated lockbar mech is rebuilt and installed along with the transformer panel.
|
100
About ready to start the wire harness portion.
|
101
Went with white flipper buttons on this game.I think it looks much better than the red.
|
102
This is the original door.It was nice and straight so it has been regrained.
|
103
Door rebuilt and installed.
|
104
Wiring the cabinet is the next step.Starting with a new cord.This one is missing the ground pin.
|
105
Wiring is in place.
|
106
I will solder a couple of things on then put the cabinet on legs.At that point I will move to the playfield swap/rebuild.
|
107
Cabinet rebuild is complete and it has ben fully tested and set on new legs.
|
108
The displays as supplied are standard for the scoring and green for the credits.
|
109
Moving onto the donor playfield. Underside teardown.
|
110
Major assemblies and lamp boards removed.
|
111
Stripped underside.
|
112
Harness has been thoroughly cleaned.
|
113
New playfield has been cleared almost a year ago.It is a NOS playfield from the later run not a repro.
|
114
Underside is ready to prep for rebuild.
|
115
Ready to begin the rebuild.
|
116
Underside prep is complete the rail stiffeners have been refinished and installed.I am checking the fit and level of th
|
117
All this will need to be cleaned and completely rebuilt.
|
118
This will be my most correct style rebuild on an older Bally.I will be replacing all coils,using the correct 1N4148 diode
|
119
Coil rebuild example.
|
120
Have these done.I suspect the large target bank will take take a couple hours.
|