41
Head is based in black.
|
42
Lower ready for base application.
|
43
Lower is refinished in the black base as well.
After it sets a bit I will clear both the head and lower.
|
44
Cabinet has a barrier coat of clear applied.
|
45
This will be sanded then stenciled.The final clear applied will be a matte finish with some sheen but not as glossy as it
|
46
|
47
The playfield has been prepped and cleared once.I have sanded it one more time and will apply the final clear.
|
48
Final clear applied.
|
49
|
50
I will let this cure a bit while I continue on with the rest.Once fully cured I will sand and polish it prior to rebuild.
|
51
Upper playfield was cleared once.
|
52
Prepped for a second clear.
|
53
Upper final cleared.
|
54
|
55
Cabinet is prepped for the next color.
|
56
Stencils for the yellow are being applied.
|
57
Head stencils applied.
Corrections will need to be made later since these are not exactly accurate but they do provide a
|
58
|
59
Since yellow is going over black a light coat of white is put in place first.This will help make the colors pop and enable
|
60
Yellow is applied.
|
61
Unmasked.I set the new head on top of the old one to help highlight the color match and alignment.
|
62
Lower being being unmasked.
|
63
Now that the yellow has flashed off I will get the red stencil in place.
|
64
The red stencil for the head is WAY off so it needs much correction.
I have cu and placed it a section at a time and did
|
65
The front was the same as the head so corrections have been made.
|
66
Ready to spray the red.
|
67
Red applied.
|
68
Red unmasked on the head.There will be some rework later to tighen up the stencil and make it as accurate as I can but for
|
69
Lower unmasked.
|
70
|
71
Lower cleared.
|
72
Head cleared.
|
73
This is a gloss coat used for leveling and sealing purposes after it sets up I will sand it and do some rework and accurac
|
75
Cabinet is being sanded for the next round of repaints and accuracy enhancements.
|
76
Cleaned and ready to repaint as needed.
|
77
|
78
This is done one panel at a time.Starting with the black.
|
79
During the leveling process it is pretty common to sand through a spot here or there in the colors.It is usually the last
|
80
More accuracy reworks.
|
81
Sharpening lines fixing break throughs.
|