82
Fixing the other sides eye problem.
|
83
Tightening up break throughs.
|
84
Accuracy reworks on the front.
|
85
Another glaring problem is the difference in the horse head on the right side front.On the left the horse is pretty accurat
|
86
Yellow is down to tighten up that part.The red will be done a little later.
|
87
Red is sharpened on the other side of the head.
|
88
The final reworks to the front are done and the horse heads match much better now.
|
89
Lower is ready to clean and clear.
|
90
Head is ready to clean and clear.
|
91
Head is cleared again.Still in gloss right now.
|
92
The corrections have really improved it IMO.
|
93
Lower cleared once again.
At this point it will need to be sanded slick once again,checked over for any cut throughs or
|
94
Ready to sand again.
|
95
Sanded.
|
96
I will do this part one side at a time.I am overmasking to soften the edges. Very slow process cutting out the tape.
|
97
Black lightly misted.
|
98
Untaped.
|
99
Same process other side.
|
100 (2)
|
101
|
102
Front is being done as well.
|
103
|
104
Head is prepped to have the black freshened up.
|
105
|
106
|
107
Head has the final gloss clear applied.
|
108
Lower has the final gloss clear applied.After it cures overnight the final matte clear will be applied and the cabinet wil
|
109
Lower sanded for the final clear.This will be the less glossy finish.
|
110
Head sanded.
|
111
Lower ready to clear.
|
112
Head ready to clear.
|
113
Matte clear applied to the head.Still fresh in this picture but will die down a bit as it dries.
|
114
Head is curing.The picture isn't a very good one because it is right up against the wall but it shows that the gloss leve
|
115
Lower freshly cleared.
|
116
Lower has started to flash off so these pics are an indicator of the gloss level.
|
117
|
118
Probably a little harder to make out on black but the cabinet is reflective but not nearly as glossy as a straight clear.
|
120
Cabinet is dry and ready to detail.
|
121
Nice real wood floor.This is a big upgrade over the original.
|
122
Since corrosion was a concern plating was the best option for the interior parts. Everything from the glass channel to th
|