204
Proper type switch is put in place.I have to make them out of sling switches since I was unable to find exactly what I was
|
205
Underside of the upper is complete.
|
206
The target banks were rewired just like the lowers and on a molex for ease of future service if needed.
|
207
Back to the cabinet since both playfileds are ready for install.Pictured are all boards freshly back from servicing.All ne
|
208
Boards are back in the head.
|
209
The inner wiring of the head is neatly in place.Anything that stays with the head after removal is anchored in a closed lo
|
210
Sections of wiring that run through the head but must be removed when the head is removed are run through an open style l
|
211
Lower is back in the cabinet.
|
212
Powered up just to check general power and ground.No power runs to the lower playfield until the upper is installed.
|
213
Lower will need a few parts installed now that it is in place before setting the upper on top.
|
214
|
215
|
216
Upper is in place.
|
217
Powered up for testing.
|
218
|
219
Installing the metal ramp section.I found that one them is not cut far enough back.I had previously shaved down the are
|
220
The fix has been made.On the right I did not shave it as deep because the ball will not go over there and I did not want
|
221
New plastic set is now in place.
|
222
|
223
|
224
|
225
Underside is complete.
|
226
Just about all that is left to do is set the flippers and install the backglass.
|
|