1
First JY in here. Looks pretty nice overall.The cabinet has a few spots here and there that I may or may not get into but

2

3

4

5

6
The back is pretty rough.I will refinish the rear of the head and rescreen it during the process.

7
The lower is a little rough as well.Someone has made there own chocks(incorrect)and the tags are missing/oversprayed.

8
The playfield looks pretty nice.

9
Further inspection shows it is already cleared once.Looks ro be an NOS that was installed.

10

11

12
There is some ghosting showing up on some of the inserts and some chipping at the hole.

13
I will do what I can with the ghosting during the process but it is not really something that can be helped because it is

14
While the cabinet and playfield are decent/nice. The assembly and hardware are not.There is a lot of rust and corrosion on

15
The resting brackets are just being used here as another example.

16
Inside is similar to the back.Missing tags dirty.

17

18
Underside is okay.Ther are some issues.

19

20
Not sure why anyone would put molex connectors on these flippers.Especially when they have the push on terminals just and

21
Light tub looks good.

22
Some overspray on the wiring.Should clean up no problem.

23
Boards look good.

24
Teardown in process. Boards removed for clean up and servicing.

25
There is a wire that is loose.Not sure if it should be there or not but I will figure it out.

26

27
Underside teardown is next.

28
There is a long jumper wire in the switch harness.No doubt it is masking an issues.It will be sorted out and corrected dur

29
Harnesses are removed and being cleaned.

30
Underside teardown nearly complete.

31
Topside teardown in process.

32

33

34
Playfield is out of the cabinet.

35
Underside stripped complete.

36
Topside stripped complete.During the rework process I will eliminate as much of the insert ghosting as possible.Very common

37
Coils will be polished and rebuilt.

38
Coils torn down.

39
Coils polished and cleaned.

40
Coils rebuilt.