81
Playfield rails are resprayed black to freshen them up and eliminate the crappy looking silver hardware.
|
82
All topside parts were polished.Even though they are new they did not shine like chrome previously.
|
83
Through parts are installed.
|
84
|
85
|
86
Ready to flip and rewire.
|
87
|
88
Magnet pole on the right was turned and polished to give it a bevel to reduce the mushrooming and give it some shine.The o
|
89
Underside rebuilt. New resting brackets are installed.They have been plated for a nicer look.
|
90
I had to relocate one bulb to get them on straight but it should light just the same.
|
91
Playfield is back in the cabinet.
|
92
|
93
|
94
|
95
|
96
Trim is being refinished.I have eliminated as much of the texture as possible.The legs are new so I can keep the game set u
|
97
Trim is based.I am using a darker black with some blue pearls in it to give a look that will be basically straight black
|
98
Cleared.While it does look very glossy right now it is actually cleared with a matte finish so once it dries it will be shin
|
99
Legs are cleared with the matte finish as well.
|
100
Gloss has died down after a few hours cure.There is refection but not too much.
|
101
Legs are now dry as well.
|
102
This is a better shot of the very subtle blue pearl in the legs.It would have to be in a very bright light to be seen but
|
103
This is a comparision o the newly refinished leg on the right to the factory leg on the left.The refinished leg is more bl
|
104
I will be replacing the larger high profile side rail screws with a flatter cleaner looking screw.
|
105
The green start button will be changed and the blank button hole will be filled.
|
106
A more color correct yellow start button is in place as wekll as the matching tournament button.I think these blend better
|
107
Rebuilt/refinished shooter assembly is in place.
|
108
I am going to clean up the interior at the head bracket mount.I will be using the older Stern covers on them.
|
109
Covers are in place.
|
110
Shaker motor has been installed.
|
111
I will be making some changes to the dmd panel next.
|
112
The clear cover is being swapped for a Pinbits red version.
|
113
Red plastic installed.
|
114
The gold grills were painted on one side and are going to show black on the face side.I did not do both sides in case it
|
115
Panel rebuilt.
|
116
Powered up for testing.
|
117
Initial test check out I will begin the requested LED conversion but I will make some adjustments to the kit since I am ma
|
118
Some of the LEDs are done in the GI.I have not addressed the feature lamps yet.
|
119
I am going with blue post in the seen areas.The upper and lower sling post are a more obscure faceted type post that I t
|
120
Left sling area.
|