121
Rebuilt coin door installed.
|
122
Playfield is prepped for the final repaints.
|
123
Shooter lane and orbit are further freshened up.I try to avoid painting these types of areas when possible but with an o
|
124
Some final border work.I am not trying to fix the registration that is commonly off on these older Bally's because that wo
|
125
Cleared second time.I left the roll over inserts out this time around because I was able to easily remove them since it
|
126
Shooter lane and orbit look good.A closer look will show that the grain of the wood can still be seen through the repair.
|
127
the previously worn area turned out very nice.
|
128
|
129
|
130
After a few days cure it will be sanded and polished.
|
131
Ready to sand.I let it set for a while and soak in.I decided it would be best to install the roll over inserts and give
|
132
Roll over insert area.
|
133
Roll over inserts were glued in.The glue was aloowed to set overnight.
|
134
Sanded and ready for final clear.
|
135
|
136
Roll over inserts sanded and leveled.So far they have had no clear put on them at all.My plan is to mask them clear it an
|
137
Final clear appied.
|
138
|
139
Roll overs should operate without needing a lot of attention.They have just about a half a coat of clear on them.I am no
|
140
|
141
Should be ready to sand and polish in a couple days.
|
142
Playfield is ready to prep and polish.
|
143
first I will refinish the back.
|
144
Underside paint applied.
|
145
Dry.
|
146
Sanded and ready to polish.
|
147
Polished.
|
148
Lower.
|
149
|
150
Shooter lane still shows a little natural wood through the repaint which is about all that can be asked for when they ne
|
151
Mid.
|
152
|
153
Loop area still shows natural wood through the repair as well.
|
154
|
155
Underside ready to t nut.
|
156
T nutted.Ground braid path is traced out as well.
|
157
Ready to rebuild.
|
158
New playfield rails are being made to replace the damaged ones.These are being done in oak.
|
159
New rails refinished and installed.
|
160
|