121
The trough is pretty much trash from the trough itself to the boards.
|
122
The "lost plastic" will be relocated to the trash.
|
123
It is a homemade piece of junk.
|
124
For some reason there is a big wooden shim under the left playfield slide.
|
125
There is not on under the right side.This would make the playfield sit higher on the left than the right.Have no idea
|
126
Slide and shim now removed.
|
127
Head gutted.
|
128
Lower gutted.All ready for the dumpster.
|
129
|
130
|
131
Speaker panel is being dealt with now.
|
132
Rusty metal,wrong screws etc.
|
133
Torndown,
|
134
Speaker panel now rebuilt.The parts were sanded,painted,polished and or replaced as needed.New speakers and a color DMD
|
135
Speaker Panel is done.
|
136
Power box.Very corroded.
|
137
Even worse is the protection have been removed from the inside.
|
138
A plated housing is swapped in along with all the poper protection being put back in place.Protections being the Va
|
139
Power box is done less the labeling.
|
140
Transformer is cleaned and refreshed :-)
|
141
Flippers will be rebuilt now.The coils are correct values and look new so while the terminals are not ideal these are
|
142
Flipper assemblies rebuilt.All metal was of course polished and new hardware was installed.
|
143
The other mechs are being worked through.
|
144
Most assemblies are now done.I will implement plugs on most of them.IJ uses a lot of assemblies but is hard to serv
|
145
The trough that was in the game.
|
146
The trough and boards that will be used to replace the old one.
|
147
The new trough is an upgraded unit with a ball stop and rails that will not wear or pit.
|
148
New trough assembled with upgraded boards..
|
149
New ramp is built.
|
150
New stainless flap was used also.
|
151
Old plastics were cleaned but will be replaced.
|
152
New plastic set that will be swapped .
|
153
The plain is rough.They are easily found but I am going to refinish this one to hopefully better match the scheme w
|
154
Old plane is painted .I did a little modification to the propeller plastic and we will see if it works or makes it into
|
155
The backpanel is refinished and a fresh decal is applied.
|
156
The POA is ready to swap out.
|
157
The POA is swapped to my restored spare.
|
158
The new gun is back from powder coating.It looks great.I am tempted to do something with the grip but honestly i
|
159
Cabinet is all set.All the parts are done.My next and final move will be polishing the playfield and building it back
|
160
|