41
Another problem is the previous person damaged this insert.It is raised and will need to be reset before bei ng refinish
|
42
There are a couple small nicks to address nothing major.
|
43
The shooter lane is a bit rough but will sand up nicely I am sure.
|
44
I am working on leveling the raised insert.
|
45
Hard to tell this in a picture but the insert is now level.
|
46
The underside needs to be dimpled next.
|
47
This is how the underside should look in terms of hole locations.This is another TOM playfield that I will use to template
|
48
I have made the template and have started the process.
|
49
This is an example of the holes needed.
|
50
Dimpling(more like pre drilling) complete.
|
51
Playfields is now sanded and ready to begin rework.
|
52
Shooter lane is sanded and has a much nicer look and texture.
|
53
Inserts are now level.
|
54
Treated with adhesion promoter.
|
55
First I am just going to rough the lighter color in.I am doing this because I need a ground floor and perfect level pr
|
56
Cleared for the first time on my end.
|
57
Shooter lane looks good now.
|
58
Even though I only roughed the initial repair in it already looks much better.Most important moving forward is that it is
|
59
|
60
After this cures a few days I can get back to it.
|
61
I will now start really getting into the teardown.
|
62
Head is gutted. All boards will need servicing.With the exception of the replacement DMD driver all others are poorly repai
|
63
Underside teardown in process.
|
64
Solenoid and lamp harness are removed.
|
65
|
66
|
67
The trunk cable is no good.I don't know if it was working but it is so twisted that I doubt it would be for much longer.
|
68
The twist goes all the way through.
|
69
This game is missing a lot of hardware nothing too much that I can't source or make but it is just one of those games w
|
70
Same problem other side.
|
71
Underside wiring is removed.
|
72
Topside teardown nearly complete.
|
73
Playfield is out of the cabinet.
|
74
Underside stripped bare.I will leave the T nuts because I am going to use all new ones during the rebuild.
|
75
More missing hardware.Here you can see the metal bracket that goes under the hinge bolts is missing.
|
76
Same problem other side.
|
77
There is an extra hole inthe back of the cabinet.It will be repaired..
|
78
The transformer is very rusted,the metal is severely corroded.
|
79
Cabinet teardown in process.
|
81
Wiring and most parts are removed.
|