41
Underside floor is sanded and being masked off.
|
42
Side walls are sanded and will be repaired as needed.
|
43
Inside floor is sanded clean.
|
44
Masked inside and ready to begin repairs.
|
45
Areas of concern are being filled.The corner on the right was loose and out of square.It had been resquared,screwed and
|
46
|
47
The seams and nail holes are being eliminated from the rear of the head.
|
48
The back panel is now complete.
|
49
The front of the cabinet is pretty rough because of the factory holes as well as the damage at the leg areas.No big deal
|
50
Getting better.
|
51
Repairs are just about complete.
|
52
Repairs are complete.
|
53
Ready to prime.
|
54
Head primed and guide coated.
|
55
Lower primed and guide coated.Will be ready for final sand,paint and clear after an overnight cure.
|
56
Lower sanded and prepped for final paint and clear.
|
57
Lower remasked.
|
58
Head is final sanded.
|
59
Cabinet is based in black.
|
60
Lower final cleared.Wet in the pics but will gloss down as it cures.
|
61
Lower has dried overnight and is unmasked.
|
62
Floor sanded up nice and clean.
|
63
Sidewall are straight all damage was repaired.
|
64
Lower is sanded and prepped for decals.
|
65
Head is being prepped for screening of the warning text.
|
66
|
67
Head is screened.
|
68
Lower is prepped and braided.
|
69
Side decals are being applied.
|
70
Front decal is applied.
|
71
Head decals applied.I will finish the edges next and then begin the rebuild.
|
72
Edges are finished.New rails are installed.
|
73
Internal meatl was plated as needed to eliminate corrosion and give a long lasting durable finish.
Transformer plate is
|
74
Head is now mounted on lower.
|
75
|
76
Boards are back from servicing.All required rework.I have swapped the driver board out for a nicer one because it was badly
|
77
Baords are installed.
|
78
Cabinet is wired.Coin door refinished and rebuilt.
|
79
Upgraded speakers.
|
80
Neatly wired.
|