1
Game as it arrived.

4
Unpacking the game.

5
Game is set up.

6
Average game over all,Cabinet is a little beat up but typical.

7
Playfield is average maybe just a bit below in terms of wear but fine for our purposes since it will be replaced.

8

9

10

11
Inside is average.

12

13
Game has the wrong flipper coils.Not a big deal as I will change them out in the process.

14

15
Moving to the NOS playfield.

16

17
Mylar sections will be removed first.

18
Playfield is ready to prep for the first clear application.

19
Shooter lane was reworked a bit for a clearner look and smoother transition.

20
Playfield is sanded and ready for the first clear.

21
First clear applied.Shooter lane rework is highlighted in this picture.

22

23

24

25
While the playfield cures I will move onto the cabinet.

26
I have a spare AFM cabinet that I have stripped and repaired.This will help speed up rthe process.

27
Cabinet is ready to prime.

28
Cabinet is primed and guide coated once it dries fully I will sand and refinish it.

29
Playfield is prepped and ready for the second and final clear application.

30
Final clear is applied.After it sets about a week I will sand it and final polish.While I wait for it to cure I will get in

31
Game is being torndown.

32
Driver board will need some work in the GI section and connectors as it shows burn and poor repair.Nothing out of the ord

33
Head is gutted.

34
Playfield is being torndown topside first.

35
There is a "homemade" ball guide in this picture.I should have a correct one from a parted out AFM to donate.

36
Here is the "ball guide" now removed.

37
Jet bumpers are built incorrectly.The steel armature should be on top and the bake lite on the bottom.

38
Wiring is removed.

39
Underside is almost stripped complete.

40
Topside is almost stripped complete.

41
Playfield is out of the cabinet.

42