81
Ready for rebuild.
|
82
Rebuilt .
|
83
Moat will be swapped next.
|
84
New moat rebuilt with new wiring and a switch.
|
85
All harnesses have been throughly washed and dried but of those only the switch harness needs a complete rebuild the
|
86
The sling switches should polish and straighten out just fine.All the targets will be replaced.
|
87
All the roll over switches will also be replaced.Few are correct or seem to be working.This is the wrong switch.
|
88
This switch has a broken wire activator.
|
89
The troll targets are in correct.All new targets will be installed.
|
90
Sling switches polished Merlin targets replaced.
|
91
New correct troll targets in place.Switch harness rebuild is complete.
|
92
This is the trash that came out of the switch harness.
|
93
I will rebuild and rewire the trolls now.
New switches and troll heads with yellow LED eyes will be used.
|
94
Trolls are rebuilt.
|
95
Trolls now have extended wiring and a single connector to make the install clean and removal easy.
|
96
The apron will need to be refinished.I should be able to save the original art if not quality decals are available.
|
97
The main issues with the apron are the return area wear.
|
98
Also there is bubbling on the backside.
|
99
The bubbling is rust.This game has seen a good bit of moisture.All will be taken care of.If ever there was an MM that coul
|
100
Rust is sanded out of the apron.
|
101
Tracks are also sanded out.
|
102
Apron is metal etched and primed.The primer is black so it might look repaired but it is not.
|
103
I will let the primer set a bit.
|
104
Next I will work on some of the coils assemblies.They are bea,corroded etc so it will take an effort and time above and be
|
105
Also working on the jet bumpers.
|
106
Jets bumpers torn down.
|
107
Lost of broken or incorrect parts.
|
108
The correct bracket are in place and have been polished.All other parts are polish or replaced.
|
109
Jets rebuilt.
|
110
Trough is polished and rebuilt.A Pinbits sleeve is installed to eliminate the pitting or ball hang ups.
|
111
These are done.
|
112
Now I will do the flippers.
|
113
The plate is cracked at the stop mount so it will need to be replaced.
|
114
This is the pile of trash from the flipper assemblies.
|
115
These are all the new parts.Coils,plates,bushings etc.
|
116
Even though the parts are new they are still polished.
|
117
Flipper assemblies rebuilt.
|
118
Other coils to be rebuilt.
|
119
Merlin kickout will be replaced.
|
120
Catapult needs work.
|