1
Starting platform.
|
2
Teardown underway.
|
3
Cabinet ready to begin process..
|
4
Many gouges etc to fill.
|
5
Stripped down to bare wood all the way around.Notice the pile of decals in the floor.
|
6
|
7
Almost ready to prime.
|
8
Primer applied.
|
9
|
10
|
11
|
12
|
13
|
14
|
15
|
16
Decals applied to lower.
|
17
|
18
|
19
Playfield rebuild in process.
|
20
Cabinet rebuild continues.Polished siderails installed.
|
21
|
22
Underside rebuild in process.Switch harness installed.The switch harness needed much work.Most of the targets and switches
|
23
The sling assemblies are very beat.Someone has used a flipper switch in place of one of the sling switches.It also had the
|
24
Sling assemblies have been completely rebuilt with new switches,coils and brackets.
|
25
Sling assemblies.
|
26
The jet bumpers are in a similar state as the slings.The pig tail is missing entirely on the right and it was wired direct
|
27
Jet bumpers rebuilt with new coils plungers etc including the proper wiring.
|
28
The flippers are like most of the rest of the mechanics on this game.The coils are incorrect in terms of strength.
These
|
29
New flipper assemblies.
|
30
The underside is nearly complete.I have also installed a new updated trough since the original was badly pitted and had aga
|
31
Like the other mechs in the game the Ringmaster assembly needs some serious attention.I am going to tear it all the way dow
|
32
The first thing I ran into is that the board is burnt up and poorly repaired.
|
33
The next thing I found is that the cam and shaft is riged and missing a few of the factory parts.I seriously doubt theyu can
|
35
the rear portion has been clened and a new motor w/gearbox installed.
|
36
The bad switches were replaced.
|
37
the cam wheel has been cleaned and reinstalled.
|
38
The other components have been cleaned as well.A new spring and Jackpot decal are being used.
|
39
Re assembly almost complete.
|
40
I hve made a new washer that is much smaller and used a much more durable grease(sparingly)that will not gum up.
|
41
As luck would have it I did have a spare board in my parts stash.
|