42
Ringmaster assembly rebuilt and ready to go back in the game.It might not look like that big a job but I had a few hours in
|
43
Playfield is now back in the cabinet and powered up for testing.
|
44
|
45
|
46
|
47
|
48
Game is almost done.
|
49
|
50
|
51
Just need to install the ramps and a couple other odds and ends.
|
52
The lamp panel for the backbox isa disaster.It has been taped together with packing tape.
|
53
Tape on the inside as well.
|
54
Its bad enough to warrant a complete teardown.The cracks extend under the decal so that will need to be replaced.
|
55
Once the tape is removed along come the remaining parts.As the picture shows this panel has some serious issues.
|
56
After a thorough cleaning I have ground and notched the panel.I am using raw fiberglass resin to repair it since strength
|
57
Fiberglass is roughed in.
|
58
|
59
Panel is refinished with plastic primer and the proper paint.
|
60
|
61
New decal applied.
|
62
Panel is reassemled on the backside.
|
63
Topside of panel reassembled with the proper coil and a bell.
|
64
Backglass ready to go back in.
|
64a
|
65
Game is basically done.
|
66
Went with the yellow bats and green rubber.
|
67
|
68
|
69
|
70
Roller switches installed in the high wire lock.
|
71
Screws used in the neon cover instead of rivets.
|
72
|
73
Game finished
|
74
|
75
|
76
|
77
|
78
|
79
|
80
|