41
I will rebuild it with nicer sockets.You can't get these new that I am aware of so my stock of good used ones will be p
|
42
Old sockets removed.
|
43
Panel is being built.455 blinker bulb conversion was done as well to eliminate the obsolete 545 blinkers
|
44
Panel is built.
|
45
New connector.
|
46
All metal polished.
|
47
|
48
Lamp panel is ready to go.
|
49
I will deal with the boards now.
|
50
Transformer section of both the harness and driver are hacked and will need attention.The secondary harness has other is
|
51
Under playfield boards will need some work and upgrading also.
|
52
the opto board is suspect.It has been heavily reworked.
|
53
|
54
On the left I have what looks to be a nice used board here that may be a suitable replacement pending testing.On the
|
55
The proxy sensor board will be modified based on what we have to start with.I like the direct wire because it elimina
|
56
Proxy board reworked in a much better manner with protections in place.
|
57
Since we were going to be short on the wiring it made more sense to install a molex plug at the junction.Should be more r
|
58
Serviced driver.
|
59
Since we are adding the third magnet we will need to populate the section of the 8 driver to power the magnet.
|
60
Populetd the 8 driver for the added magnet.
|
61
The buy in button switch/ wiring runs too short and can chafe the power box so it will be reworked.
|
62
Buy in button switch reworked.
|
63
Tear down is progressing.Moves slower using this method but pays off on the back end during rebuild.
|
64
New plastic set will be installed.
|
65
Swapping these out polishing each part as we go.
|
66
|
67
Now for the clock.This one is a wreck so total teardown,board and hosing replacement will be required.
|
68
|
69
|
70
Junk did not even have bulbs in it.
|
71
Clock completely torndown.
|
72
All parts are thoroughly cleaned.Ready to rebuild.
|
73
Clock rebuilt.Since this is going to be a pretty loud restoration visually the colored version of the decal makes the most
|
74
Supplied chrome housing is installed.
|
75
I will now start going through some of the other removed parts.
|
76
The gumball machine is up next.
|
77
Comepletely torn down.
|
78
Motor and gearbox are cleaned serviced and polished.An extended cable was made for the motor with thicker wire so it wil
|
79
The thicker wire is especially beneficial at the solder points.
|
80
All parts were cleaned and it is now being rebuilt.
|