41
Continuing teardown.The deeper I get into it the rougher I realize the game is.
|
42
Playfield is out of the cabinet.
|
43
The loom holders are trash.Between the corrosion and bends they are not worth reusing.
|
44
The amount of corrosion and rust throughout is rare.Everything is corroded.The coil brackets further down in the harness
|
45
The switch brackets are corroded.
|
46
|
47
Some creative fixes like double diode to sort out as well./
|
48
Switch harness is out.It will need a new everything and a lot of cleaning/rewire.
|
49
All the target will need to be replaced.I will do all I possible can with the brackets.The small brackets like the switch
|
50
Wiring harnesses are removed.
|
51
Playfield is bare.
|
52
|
53
Will finish gutting the cabinet now.
|
54
Has a mod on the head.Will try to save that.
|
55
Head stripped down.
|
56
Lower gutted.
|
57
Going to fix the transformer up next.Just needs a little connector work and clean up.
|
58
Transformer refreshed.
|
59
This might be the worst of the task left on this restore.Working through the coils and mechs.
|
60
Some side by side comparisons what I start with on the left what I end with on the right.
|
61
|
62
|
63
|
64
|
65
|
66
Most of the coils are done now.
|
67
The thing kickout is best replaced with the upgraded stainless version.
|
68
|
69
Bookcase being rebuilt.
|
70
|
71
Working through the thing motor and gearbox.It is very rough so I will; do what I can cosmetically althought this will mos
|
72
|
73
Replacement playfield has been fully reworked and cleared.It is now polished and ready for rebuild.
|
74
|
75
|
76
The lower area where the blank purple bar code was has been repainted to flow with the rest of the art in the area.The g
|
77
|
78
|
79
the chair hole was correctly beveled on all three sides.
|
80
|