81
Here is the flipper wiring.It is too short on all 6 wires so I will make repairs farther back staggered in pattern so they
|
82
Soleniod harness has been run and the flipper wiring repairs are complete.
|
83
Playfield is back in the cabinet.The DMD panel has been stripped cleaned and rebuilt with new clear lense.The game is power
|
84
|
85
|
86
All the ramps are broken so each will be replaced.
|
87
I am gaoing to do allthe flaps in stainless.The other parts are regrained.
|
88
New ramp assembled with new decal and switch for reliability.
|
89
J Ramp to be replaced.
|
90
New J ramp built with new switch and regrained parts.
|
91
Two newly rebuilt ramps are installed along with the plastics.
|
92
|
93
|
94
Mine hole repair with protector.
|
95
Roll over areas left.
|
96
Roll over areas right side.The shooter lane does have a subtle definition in it that is hard to see in the opicture.It is n
|
97
The new ramps are reinforced in the week spots to help make them more durable.
|
98
Game is pretty much done just need to swap out 3 more ramps and button it up.About a half a days work.
|
99
Back to swapping ramps.Skill shot ramp is next.Using a repro.I will swap the flap for a stainless one to match the rest dur
|
100
Have a couple of these ramps laying around as broken up used assemblies so I was able to rebuild another without depopulat
|
101
Next ramp to be swapped.This is actually the worst one of the group because it has the plate,two switch holders the flap,t
|
102
Ramp has been rebuilt.
|
103
Finally the train ramp.
|
104
Train ramp rebuilt.
|
104a
All the ramps are installed.The wiring was run through clear tubing.All the switches were replaced.The mountain over t
|
105
All done.
|
106
|
107
|