1
Twilight Zone Proto playfield as it arrived.

2
Shooter lane has ground in dirt and it will need to be well sanded and shaped to eliminate the rough routing grooves t

3
Chipped at the wired guide.

4
Typical ball drop damage at the switch cut out.Not too bad though.

5
Insert wear and edging on all inserts.

6
Better shot of the insert issues.All will likely need to be repainted to eliminate the cracks and light gaps.

7
A scrape is going through the jet bumper area.

8
Ball swirl in the jet bumper area.This is a tough area to fix because of the color and how small the patterns are.

9
More insert edging.It is in other colors besides the black as highlighted by the powerball insert.Showing in the blue and th

10
Ramp flap damage is deep and will need to be filled.

11
Spiral insert used to actually say Gumball but it was scraped off and a rough sticker that says spiral was place.It will

12
The area at the gumball exit will need some filler and repaint.

13
This area should sand up clean and is hidden once rebuilt.Thee are some stray black marks around the bordering that will

14
Playfield is sanded.

15
Shooterlane is worked out to a respectable level .

16
The damaged areas that require filler are being addressed now.

17

18

19
Crappy insert decal is removed and the insert is prepped as well as possible considering how rough they were in removin

20
Fill work is finished out.

21
Gumball exit area is repaired.

22

23
Replacement insert decal installed.I sometimes prefer to clear first then install but I don't want to have to build it

24
Jet bumper are is ready to repaint.This is a repair that reall needs to happen on the ground floor be cause the area is com

25
Playfield is treated with adhesion promoter.

26
Jet bumper area is repainted only as needed to minimize the possibility of the repair being noticeable.

27
Jet area unmasked.Looks good prior to clear will look better or worse once clear is down.

28
Wireguide chip is roughed in.I will finish it out later on the second round for now just getting it in place.

29
First clear applied.

30

31

32
Jet area look even better clear.Good.

33
After this cures a few days I will sand it down and begin the repainting process for the more cosmetic issues.The first r

34
Playfield is sanded and ready for the next round of repaints.

35
I will address the wood tones.The ball drop damage will be refinished.I do not put filler in this area though because it wou

36
Wood tones lightly refinished as needed.

37
Areas unmasked.

38

38a
Gumball exit area refinished.

39