1
Got another TZ playfield in to redo that was done elsewhere.This one is pretty bad in terms of the clear application.

2
Shooter lane is really rough.

3
Badly solvent popped all over the place.This really shows up in the darker colors and will have to be stripped or repainted

4
Not sure what is going on here it looks like someone took a knife to some areas.I will try to sand this out but it is probab

5
Some small bubbling in the insert.This isn't a big concern it is likely factory ghosting magnified or loosened by the cle

6
The gumball exit shows wear and solvent pop.

7
Solvent pop at the target cut outs.

8
Just rough,solvent popped and thick is about all I can say overall to summarize.

9
This is a good shot to show what it will take to be sanded out nice and flat.There are some deep spots here not to mention

10
Overall the sanding is done.I still need to focus on some areas.To get to this point has taken quite a bit.It has to be do

11
This picture highlights that it can only be sanded so far and once it starts to show breakthrough that is it I have to s

12
Shooter lane area sanded up well in the main lane but I can't get the cuts out without breakthrough so I will rely on r

13
I have been able to take the target area down far enough to eliminate the solvent pop and only require some minor repaint

14
Still need to sand a bit more in this area if that doesn't work then I will see how it looks once cleared the first tim

15
Sanding is complete.

16
I will repair the ball drop and have been able to eliminate most or all of the solvent pop.

17
The white specs are gone.

18
Shooter lane area looks a lot better but will need more work later in the process.

19
Upper section looks promising.

20

21

22
Cleaned and evaluated.Repaints will begin next.

23

24
Adhesion promoter is laid down.

25
Woodtones are being done.

26
Concerns are the gouges in the shooter lanes.

27

28
Gumball exit repaired.

29
Woodtones sprayed.

30
I have tried to mask the gouges without eliminating the natural gain.This should be a very solid compromise.

31

32
Woodtones unmasked.

33
Gumball exit looks nice.

34
Working on the gouges in the white areas now.They are the shooter lane and the left spiral magnet(not pictured)

35
Looking much better now.I can' get the dithering just right so I went with more of a solid fade.I think thaty will work well

36
Firs clear applied .It may be the final as well since this already had plenty of clear applied previously.It will really d

37
No more solvent pop and the ball drop looks good.I will clean up the cut out later now that it is sealed up.

38

39
Shooter lanes look great.I was a bit concerned about this part.I wanted to keep the natural look but needed to cover the dam

40
Center looks nice.