1
Got another TZ playfield in to redo that was done elsewhere.This one is pretty bad in terms of the clear application.
|
2
Shooter lane is really rough.
|
3
Badly solvent popped all over the place.This really shows up in the darker colors and will have to be stripped or repainted
|
4
Not sure what is going on here it looks like someone took a knife to some areas.I will try to sand this out but it is probab
|
5
Some small bubbling in the insert.This isn't a big concern it is likely factory ghosting magnified or loosened by the cle
|
6
The gumball exit shows wear and solvent pop.
|
7
Solvent pop at the target cut outs.
|
8
Just rough,solvent popped and thick is about all I can say overall to summarize.
|
9
This is a good shot to show what it will take to be sanded out nice and flat.There are some deep spots here not to mention
|
10
Overall the sanding is done.I still need to focus on some areas.To get to this point has taken quite a bit.It has to be do
|
11
This picture highlights that it can only be sanded so far and once it starts to show breakthrough that is it I have to s
|
12
Shooter lane area sanded up well in the main lane but I can't get the cuts out without breakthrough so I will rely on r
|
13
I have been able to take the target area down far enough to eliminate the solvent pop and only require some minor repaint
|
14
Still need to sand a bit more in this area if that doesn't work then I will see how it looks once cleared the first tim
|
15
Sanding is complete.
|
16
I will repair the ball drop and have been able to eliminate most or all of the solvent pop.
|
17
The white specs are gone.
|
18
Shooter lane area looks a lot better but will need more work later in the process.
|
19
Upper section looks promising.
|
20
|
21
|
22
Cleaned and evaluated.Repaints will begin next.
|
23
|
24
Adhesion promoter is laid down.
|
25
Woodtones are being done.
|
26
Concerns are the gouges in the shooter lanes.
|
27
|
28
Gumball exit repaired.
|
29
Woodtones sprayed.
|
30
I have tried to mask the gouges without eliminating the natural gain.This should be a very solid compromise.
|
31
|
32
Woodtones unmasked.
|
33
Gumball exit looks nice.
|
34
Working on the gouges in the white areas now.They are the shooter lane and the left spiral magnet(not pictured)
|
35
Looking much better now.I can' get the dithering just right so I went with more of a solid fade.I think thaty will work well
|
36
Firs clear applied .It may be the final as well since this already had plenty of clear applied previously.It will really d
|
37
No more solvent pop and the ball drop looks good.I will clean up the cut out later now that it is sealed up.
|
38
|
39
Shooter lanes look great.I was a bit concerned about this part.I wanted to keep the natural look but needed to cover the dam
|
40
Center looks nice.
|