1
Playfield as it arrived.

2
The T nuts etc will need to be removed from the bottom.

3
T nuts removed.

4
Ready to evaluate and begin doing some initial repairs.

5
The shooter lane is very rough and dirty.Should sand up okay.The biggest concern will be just how much of the ground in di

6
Lots of ball swirl.Some of it is in areas that are dithered and will be impossible to duplicate exactly.

7
The red Special insert is melted and will need to be replaced.Luckily I have a scrap IJ playfield I can get one from.

8
More ball swirl.

9
Same thing other side.

10
The green round inserts have some type of clarity issue.Not positive how well this will be taken care of during the proc

11
Same thing other side.

12
The two inserts pictured are damaged.Likely happened during an attempt to remove mylar.

13
Many holes are drilled in this area.None belong there and this area will require a bit of work.The green will be a tough

14
The holes pictured will need a little fill work.Mostly for cosmetics.

15
The damaged insert is removed.

16
The replacement is glued in place.

17
Playfield is now in the refinishing area and ready to prep for an inital clear application.I won't do any repaints prior t

18
Holes are filled.

19
Filler is sanded.

20
Lots of little poke throughs here and there become more obvious as the playfield is sanded and leveled.

21
Shooter lane took quite a bit of sanding but is at least respectable now.

22
Other minor things here and there.This playfield will require a lot of repaint.

23
Playfield is now ready for the first clear application.

24
First clear applied.

25
Playfield has cured overnight.After a few days I will sand it and begin the repainting process.

26
Playfield has cured and is now sanded.

27
I will do all the yellow work first since it is one of the bigger issues.

28
A little more filler work is needed prior to.

29
Playfield is now cleaned and treated with adhesion promoter.

30
Yellow is masked and sprayed.

31
Yellow unmasked.

32
Next issue is the white background around Indy.There is staining or ball swirl in that area.It is not a straight white it i

33
area is masked and sprayed,Might be hard to see in the pics but there is a yellow used to make the transition to white.

34
Indy background unmasked.

35
Damage to the upper red area and transition is sprayed.

36
The ball swirl in the lower dithered areas is sprayed now as well.This is an extremely difficult repair to do.It takes se

37
Dithering repairs are unmasked.

38
These look very good.Probably some of the best I have done to date.

39

40
Upper red repairs unmasked.