1
Playfield as it arrived.

2

3
Shooter lane shows some ground in dirt.

4
Ghosting on several of the inserts.

5
Chip at the boom balloon and into the lettering.
also wear at the Volt roll over to the wood.

6
Ghosting of inserts and wear at the Ringmaster cut out.

7
Playfield is ready to prep for the first clear.Hope to eliminate most of the ghosting and seal it at this point.

8
Chipping at the trough entrance.

9
Trough chipping addressed.

10
Shooter lane sanded as clean as possible.CV is tough with such a short lane.

11
Playfield is prepped and ready for an initial coat of clear.

12

13
First clear applied.

14
Cleared up as much of the /most of the ghosting.

15

16

16a
Playfield has cured for a couple weeks now sanded and ready to start the repairs.

17
Cleaned and ready to start painting.

18
Shooter lane and lower wood tones need rework.

19
Inserts will need a little more work as well.

20
Touch ups needed to fix the gouges here and there like this one near the polar bear on the left of the screen.

21
Will start repairing the boom balloon area also.

22
Ringmaster cut out is ready to fix as well.

23
Wood tones are sprayed.CV is very tough because there is a lot of lettering in the lower area and that is surrounded by na

24
Wood tones unmasked.

25

26

27
Will rework and lay the foundation for the boom balloon now.

28
Yellow is sprayed.

29
Will add the lettering now.

30
Lettering is added and the outline of a border.That will need more work later but the blueprint is there.

31
JTC insert border needs to be repainted.

32
Border repainted.

33

34
Fixing the Volt roll over wear .

35
Unmasked and ready t clear again.

36
Second clear applied.

37
Lower areas are looking much better.

38

39