|
1
BSD playfield as it arrived.
|
2
Shooter lane has a lot of ground in dirt.
|
3
Ground in dirt and minor ball drop damage at the switch cut outs.
|
4
Damage at the rat hole.Insert bordering at draculas face as well as many other spots.
|
|
5
Target bank area is a little hammered.
|
6
Mylar removal/insert damage.
|
7
Some wear at the various holes.
|
8
Underside is dirty and still has the t nuts.
|
|
9
Underside is stripped down now.
|
10
Topside is cleaned.
|
11
Shooter sanded and shaped as well as possible.
|
12
Insert stripped as needed.
|
|
13
These areas in the wood will need to be refinished.
|
14
All the holes that pass through are sanded clean first.
|
15
Target bank area reworked a bit.
|
16
Playfield is ready to go into the refinishing process.
|
|
17
Playfield is sanded.
|
18
Hole damage repaired.
|
19
|
Ready for an initial coat of clear.This playfield is too fragile right now to do any taping on quite yet.
|
|
First clear applied.
|
22
|
23
|
24
After a couple days cure I will sand the playfield and begin the repaints.
|
|
25
Playfield is sanded and ready to begin the repainting process.
|
26
All the wood tones will need rework.There is a lot of discoloration and burn present.
|
27
|
28
Highlighting the bulb burn here.
|
|
29
|
30
Switch cut out dirt,sling area burn.
|
31
Wood masked and skillfully refinished.This is done in a way that does not cover the natural grain but does eliminate and d
|
32
Shooter lane remains natural.
|
|
33
Woodtones unmasked.
|
34
|
35
Burns eliminated.The more hmmered switch cut out on the inner lane will need more work later in the process but for now it i
|
36
|
|
37
|
38
|
39
This area was very burnt so it shows good improvement.
|
40
|
