42
Cut out refinished.
|
43
Uppers were done as well.
|
44
Uppers unmasked.
|
45
Lowers umasked.
|
46
The following pics will help better highlight all the break throughs in the clear from the leveling process.
|
47
Break throughs cont.
|
48
Break throughs cont..
|
49
Break throughs cont...
|
50
More break throughs.
|
51
More break throughs ....
|
52
Break throughs I think.Lost track.
|
53
I tightened up the border on the gum insert to help mask the minor issue on that.The lock isn't too bad and it is better
|
54
I was able to neaten up the magnet holes through very careful sanding with properly sized and shaped objects.
|
55
Playfield is ready to clear.I did not mess with the colors because while the red/megenta is off it is consistent.Had I
|
56
Playfield is cleared.
|
57
I will take several pics from differnet angles to help highlight the improvement in the level of the playfield and the thinn
|
58
Shooter lanes are closer to the correct shape and size.
|
59
Bleed through is gone.
|
60
Door panel is straight.
|
61
Switch cut outs other side.The match is pretty good,Definetly looks better than black.
|
62
Light reflections pics for straightness verification.
|
63
Light reflections continued.You can check these against the intital pics for comparision.
|
64
|
65
|
66
Magnet holes look acceptable.
|
67
|
68
Swapping the direction of the playfield under the lights.It is still wet so I tread lightly.
|
69
These pics help check the side to side level.
|
70
Side to side is much improved.
|
71
Switch cut outs from a similar angle as the first I took when the playfield arrived.
|
72
Level picture.
|
73
Gum insert from a similar angle as the inital pics..
|
74
Shooter lane.
|
75
Lower .
|
76
After it sets a couple days I can better determine if more work is needed or if sand and polish is what is left.
|
|