1 Mirco repro MM playfield.
2 Shooter lane is a bit narrow.
3 Compared to this original shooter lane.
4 Missing the ball guide cut out on the lower left.
5 Should be like the original pictured here.
6 Notch has been cut out in the repro now.
7 Ball guide fits properly.
8 Castle lock area needs work.Wood is chipping at the edge.
9 Caslte protector fits pretty well.The area is a bit too deep but it is probably okay over all.To highlight though you can see
10 Protector when seated on the original.Sits more level and correct.
11
12 Repairs are being made.
13
14 Sanded the entire playfield.Shooter lane was corrected.
15 Wood tone faked in on the repair.Not a perfect match due to the really unusual wood used on these playfields which is really
16 Unmasked.
17 Ready to clear.
18 Cleared.
19 Shooter lane now corrected and cleared.I did my best to get a decent looking graduation betweeen layers.Always tough on thes
20
21
22
23
24 After a couple days cure I can determine if it will require further rework or final sand and polish.
25 Playfield has cured and will benefit from one more session of sanding and clear.
26 The shooter lane is really what dictates the need for another application.When widened it cuts into the raw wood and that
27 Playfield is being sanded.
28 Ready for the final clear.
29 Final clear applied.
30 Shooter lane is all set now.Once it cures a bit it will be ready to sand and polish.
31 Playfield has been sanded and final polished.
32
33
34
35
36
37
38 Ready to pack and ship.