1 BSD playfield as it arrived.
2 Shooter lane is decent has some deep ground in dirt that may not completely sand out due to the rougher routing and th
3 Typical ball drop damage at the switch cut out on the left inlane.
4 Typical damage at the hole entrance and insert bordering through dracs face.
5
6
7 The holes are a bit rough as well.There is a furriness to the cut outs that will have to be smoothed in or filled.
8
9 Playfield is being prepped for the first clear.
10 Shooter lane is sanding up pretty well there may be a little dirt left behind .I will know more once cleared.If there is
11
12
13
14 First clear applied.
15
16
17
18
20 First clear has cured and is now being sanded so I can start the actual leveling and repair process.
21 The inserts in the middle are raised and will need some border work as they are leveling out.
22 The switch cut out is more solid now and can be reworked at this point.
23 Repairs are being made to the cut out.
24 The other holes are also going to require fill work.
25 Repairs are sanded and the playfield is cleaned.
26 Shooter lane should be fine in natural wood.Might have a few minor ground in spots but nothing worthy of losing the
27 Until I am comfortablethe inserts are truly flush I won't repaint the borders because they will just be sanded off and
28 I will handle the repaints in this area next. They will include roughing in the cut out area and fixing the insert border
29 There are some other raised inserts here and there that will need a slight touch.
30 Holes are now smooth and solid but will require a good bit of repaint.The borders on these are tough because they are
31 Same thing on the larger hole.
32 Wood tones are done where needed.Just roughing in right now.
33 Yellow work and dracs face are being done.
34 Ready for the next clear.
35 Second clear applied.
36
37
38
39
40
41 Playfield is improving but needs more work.