1
Starting out with a strange mix on this game.Playfields look pretty good but the cabinet and wiring are very poor.
|
2
The front has several holes in it.
|
3
|
4
The sides were repainted with a VERY thick coat of latex paint or at least I think it is latex.It has to be a 1/16th of an i
|
5
Same paint issues on the back along with many poorly done repairs to the lower edge from either moisture or delamination.
|
6
Playfields are not bad.There is the typical wear at the ball drops,kickout, and raft inserts nothing unusual that I can see
|
7
The ramps look better in pics than they really are because there are holes drilled in them and glue all over the place fro
|
8
The apron is okay but not on the game properly.I haven't determined if that is because it has the wrong brackets or was jus
|
9
The head mounts are blown out and just regular bolts are used to hold it in place.
|
10
Same issue on this side but ther is an additional bolt trough the cabinet.Not sure what the logic was there.
|
11
Underneath is dirty and disorganized but even worse there are numerous hacks,rigs and missing parts.Nothing game specific b
|
12
Hacked into the wiring are the little boxes to run the EL wiring.
|
13
|
14
|
15
Lots to address inside.
|
16
Power box is missing entirely.
Transformer is rusty as well but that is an easy fix.The wiring of it will need to be redo
|
17
Here is the power source for the game.What a HACK!! I guess they dumped the correct box to have power for that light thin
|
18
Another byproduct of this hacked wiring/mod/missing parts thing is there are many more holes in the cabinet and floor beca
|
19
Teardown in process.
|
20
|
21
|
22
Underside wiring harnesses removed.
|
23
Topside teardown in process.
|
24
Playfield is stripped bare topside and out of the cabinet.
|
25
Underside is stripped bare as well.
|
26
Mylar sections have been removed and the playfield has been lightly cleaned.
|
27
The switch cut outs will need to be refreshed to eliminate the ground in dirt and splintering.
|
28
Same issue other side.
|
29
Kickout wear mostly in the purple.
|
30
Insert wear on the rafts and a little spot above them in the tan.
|
31
Shooter lane is solid should sand up nicely.
|
32
Initial sanding of the shooter lane looks promising.
|
33
Fully prepped.I will catch a few small thing first then put the first clear down.
|
34
Initial clear is applied.Shooter lane is shaping up.
|
35
|
36
After this cures I will sand it then begin the repaints.
|
37
Now that the playfield has fully cured I can begin the repairs.
|
37a
Sanded.
|
38
The before pics were taken prior to sanding.
The upper blue is heavily tracked and will need to be repainted.
|
39
There is bordering in the blue around the wet willy insert.
|