159
Coin door is now in place.
|
160
Example of the wiring.Need to install a screw just above the test button after I finish verifying everything works prope
|
161
Plug is in place and neatly tied to the wall behind the tilt bob are.It will not move nor interfere with it.
|
162
|
163
Cabinet is done and almost ready to power up for testing.A new replacement speaker will be installed soon as well.
|
164
The apron needs work.It is not only scratched but more importantly it is lightly rusted under the paint.I will strip it
|
165
Stripped primed,now based in red.Playfield rails are done at the same time as well.
|
166
|
167
Apron and rails are cleared.
|
168
Was hopin g to sand and polish the playfield at this point but it just had one or two more issues on the lower inserts th
|
169
Final clear is applied one more time.The thickness is not a concern because each previous layer is sanded away and all
|
170
|
171
|
172
Playfield should be all set now.The main reason I hit it one more time with clear was to seal up the cosmetics not a leve
|
173
A good set of original displays have been cleaned up and tested.
The cabinet is powered up and all work to this point is
|
174
Everything checks out perfectly so I can move on to other aspects of the restoration now.
|
175
Stripping the old playfield.
|
176
|
177
|
178
New playfield is sanded polished and prepped for rebuild.
|
179
T nuts,new bumper bodies etc are in place along with the refinished rails.
|
180
|
181
|
182
|
183
All new sockets and braid are being placed.
|
184
|
185
|
186
|
187
|
188
Running of sockets and braid is now complete.
|
189
The clear placstics have to be replaced.There are just too brown to consider using.Since it is a thicker plastic I am g
|
190
The larger plastic is now made.I will have to make a smaller end piece for it because it is just a little too short
|
191
Homemade large clear plastic is now in place.
|
192
Smaller clear plastic is now made and in place as well.Check out the side by side comparison.
|
193
Topside rebuild is about where it needs to be prior to rewiring the underside.
|
194
|
195
|
196
All new post are installed.I have a few different runs of these some are quite dark but I liked the lighter run the be
|
197
|
198
|