123
|
124
Spinners are rough but will be reworked.
|
125
Spinners stripped via bead blasting.
|
126
Refinished with white epoxy.
|
127
Spinners now full dry and decal with only the needed art portions of the decals.
|
128
Topside built about as far as it goes with all new post ,mostly new hardware and all the reconditioned/refinished parts.
|
129
|
130
|
131
|
132
Ready to wire and rebuild the underside.
|
133
Coil brackets are being swapped with new plated versions.New coils are used in a couple of spots to keep things looking
|
134
Wring is cleaned and transferred.
|
135
Quite a bit of soldering still left to do.
|
136
All caps are being replaced on the switches that use them.
|
137
Wiring is finally complete.
|
138
Plated and polished coil brackets.
|
139
|
140
|
141
Target bank rebuilt and polished now on a connector for easier servicing.
|
142
|
143
Ready to put in the cabinet.
|
144
Playfield is now installed.
|
145
|
146
|
147
|
148
The plastics are nice for their age.I have cleaned them and will work on flattening them out.
|
149
This is the level of warping .
|
150
Also ready to decal the apron.
|
151
apron decaled.
|
152
The testing solenoid driver will be replaced at this point as I tighten up the wiring and connections.The connectors will
|
153
Some of the old connectors now removed.
|
154
New solenoid driver is installed and the connectors are rebuilt.
|
155
Powered up for testing.
|
156
New bumper caps are installed along with the cleaned,polished and flattened plastics.
|
157
|
158
|
159
Everything is looking good and working properly.I will get the backglass in order and the game will be read for final pic
|
160
Backglass is ready to go over.
|
161
The primary need is a ew channel and some clean up.These are tough to remove without damage but I should be able to keep it
|
162
|