123
Poorly repaired.
|
124
Flipper opto boards are replaced.
|
125
Eddy sensor cables are mixed.One is correct the other is homemade.
|
126
This is the homemade one in case you can't tell :-)
|
127
Correct style cable is made.I will wait to put an end on it as I may decide to direct solder both for a little better
|
128
Gun switch in the cabinet is no good.
|
129
Gun switch replaced and a new harness was made,
|
130
Now I am going to start dealing with the switch harness.The most important and troubling part right now is the ball
|
131
The previous splices made the probability of the wiring to be too short likely so I am going with a factory style
|
132
Factory correct style,color and size wire is used for the repairs.
|
133
The mating plug is made and tested for fit on a new set of upgraded trough opto boards.
|
134
To close out this section of the repair I am going to replace the trough with a factory version that has already bee
|
135
Trough is built up.
|
136
New coil and a plug is implemented with correct style and color wiring.This will make future servicing and probl
|
137
The repair is complete in this area and I can move on to other sections of this harness that are in equal need of repai
|
138
Working through the coil and motor assemblies.Starting here.
|
139
The subway poppers are in rough shape like everything else but the main concerns are some wiring issues and cosmetic
|
140
|
141
There are cut wires here and there and those were originally tapped in the wrong spots during teardown.I will be puttin
|
142
The corrosion is heavy on these parts as well but it is just that corrosion not rust so a light nickel plate will be t
|
143
|
144
Hardware to be manually polished.
|
145
Will clean and rebuild the coils and harness for each assembly.They will not need total replacement harnesses like m
|
146
Brackets are ready for plating.
|
147
Brackets now plated.
|
148
Brackets are being reassembled with the cleaned and polished hardware and repaired wiring.
|
149
|
150
Subway popper assemblies are complete now.
|
151
Now I will work on the cannon motors.This one in particular is trashed.The bracket is badly mangled.
|
152
|
153
A new set of brackets was sourced and in addition the motor was polished ,Wiring replaced and protecton put in place
|
154
|
155
Both cannon motor assemblies are now rebuilt with new brackets and enhanced wiring.
|
156
Lamp panel is next.
|
157
The panel is solid but has black overspray and has yellowed with age.
|
158
Backside the wiring is dirt and the wood is as well with black dust.
|
159
All wiring and parts are removed from the panel.
|
160
Panel will be sanded and refinished.
|
161
Panel is painted white.
|
162
All other parts of the panel are cleaned polished etc.This includes the wiring harness and sockets though they are not p
|