161
I used this set up for a free play switch.
|
162
The way the switch works is that when you push the coin eject button it activates and adds a credit.
|
163
Coin door internals are complete.
|
164
Coin door outside.Clean and no indication of the free play switch.
|
165
All the parts are now in place so rebuild can begin.
Starting with the lower cabinet.The more challenging aspect is that
|
166
Cabinet has been ground braided,new reinforced leg plates are used,transformer panel installed.
|
167
|
168
A couple minor changes are done to keep things uniform.
|
169
Plated parts are now installed like the lock bar catch .Wiring is in place.
|
170
Other plated parts installed are the rear glass channel.A new speaker is installed since the old one was trashed.A little
|
171
Wooden tilt panel assembly has been prepped and installed.l
|
172
Most of the other hardware is now in place upfront.
|
173
Lower is pretty much complete so next will be the head.
|
174
First part of the head to rebuild but not yet install is the lamp panel.New displays and polished parts are in place on th
|
175
Aux. Lamp boards was serviced.
|
176
Backside of the lamp panel is rebuilt.
|
177
The head itself is ready to reassemble.
|
178
New tin is going to be installed.This tin is true stainless steel not foil or foil paper.It grounds well the only drawback
|
179
All boards were serviced and are ready for install.
|
180
the original solenoid driver with the piggy back was not worth repair so a nice solid original was sent in its place.That
|
181
Unfortunately and as is often the case the reverb board was not repairable.The hard to come by chip was the culprit.
|
182
Luckily the aftermarket reverb board was found to be fine and properly tuned to work well with the original set.Functiona
|
183
I don't want to lose track or overlook the original reverb board since there may be a time in the future that the board ca
|
184
In order to attach it directly to the original board I am gong to put fish paper on the back side to insure it will not ma
|
185
Aftermarket reverb board is now mounted to the original in a similar position that will keep the wire routing correct and
|
186
A metal stand off was used in the screw mount to keep ground and a plastic stand off was used to make it a bit more steady
|
187
Head is as complete as possible and almost ready to install.
|
188
Lamp panel is in place.
|
189
Head is now on the lower.
|
190
Cabinet is just about complete.I have installed the old playfield briefly to make sure the fit and pivot locations are co
|
191
Interior of the cabinet is now complete less a minor ground strap or loom.
|
192
Playfield resting brackets are now installed.
|
193
Prop rod was chromed to overcome corrosion and is now in place with the rest of the hardware.
|
198
Cabinet is pretty much complete.I will likely power that up in a bit to close it out and move onto the playfield prep and
|
199
Playfield is sanded and ready to polish.
|
200
Playfield polished ready to rebuild.
|
201
Prepped for rebuild,new t nuts installed.
|
202
Wiring harness in place.
|
203
Solenoid and target bank wiring in process.
|
204
Flipper assemblies wired/in place.
|