81
Squawk and Talk and reverb board were serviceable and rebuilt.Got lucky on the reverb board as many are not repairable.
|
82
All boards are in place and the grounds have all been checked with a meter.
|
83
Head is gutted.
|
84
Lower is gutted.
|
85
head is fit on lower.
|
86
Cabinet is now drilled for the brackets etc and the plated transformer panel is rebuilt and installed.
|
87
New rails are installed.
|
88
Cabinet is back at the shop and up on legs.
|
89
The legs were painted the same silver as the stencils and the same clear as the cabinet for a perfect match.
I used bla
|
90
|
91
|
92
|
93
Lamp panel was torndown and refinished.
|
94
New displays installed.
|
95
All metal was polished.
|
96
Connectors were rebuilt as needed.New labels inside the head as well.
|
97
New coin door skin.
|
98
Plated parts for the internals of the coin door.
|
99
More plated parts for the coin door.These bally doors are a monster when it comes to parts.
|
100
Coin door rebuilt and wired.
|
101
Face of the door.I went with token plates because I like the red and black look.Matches the game and the displays.
|
102
Coin door is installed.
|
103
Ready to wire the cabinet now.
|
104
I am now ready to sort through and install the cabinet wiring.
|
105
One repair will be redressed.The repair isn't bad just needs a little protection and some improvement in the cosmetics.
|
106
Cabinet wiring is being installed.It will be done very neatly but right now it is just falling into place.
|
107
Cabinet wiring is complete.There are a few loose ends that will need to wait until the playfield is in.
|
108
|
109
|
110
Powered up for some general testing of the cabinet wiring and displays.
|
111
Cabinet wiring and displays check out.Hard to fully capture in the pictures but the displays and coin door slots are a
|
112
Ready to begin the final phase of rebuild.The playfield.
|
113
Old playfield is mostly stripped.
|
114
New playfield is being wired.These pictures jump ahead quite a bit because I was without my shop camera yesterday.
All
|
115
The targets are wired with new diodes and caps.There is a protective sleeve put on to make sure they do not easily short.T
|
116
The sling switches will be replaced as well.This game was a very rough starting platform(most games of this era are)so th
|
117
New switches are mounted.
|
118
New switches are wired in.The bare wire jumpers were replaced with color correct insulated wire to also avoid shorts.
|
119
One pop bumper is rebuilt and shown as an example.The quick close caps are replaced as well as the coils.This game was mis
|
120
Brackets were plated because they were heavily rusted/corroded.
|