1
Twilight Zone base game as it arrived.This side looks good.
|
2
|
3
This side is faded.
|
4
Some touch up work has been done.
|
5
Lower playfield looks good overall.
|
6
Apron is a bit rough will need some rework or to be redone entirely.Not a big deal either way.
|
7
Shooter guage is bent.Again not a big deal but worth noting.
|
8
Shooter lane should rework nicely.
|
9
Upper playfield area .
|
10
Slot target bent way back.
|
11
Some vertical cracking in the mini.If it can't be well repaired it will be replaced with either a better one I might have
|
12
Underside is pretty clean compared to many I get in.
|
13
|
14
|
15
|
16
There is typical corrosion on the metal.
|
17
Some rigs here and there like the gumball popper.
|
18
|
19
Slot kickout brackets is trashed.It will be replaced.
|
20
Better shot of the corrosion etc.
|
21
Translite is decent overall.
|
22
There is one touch up but I am sure once I get that off the area that needs a little work will be much smaller .
|
23
|
24
Boards are typical.
|
25
The expected burnt GI connectors.All boards will be serviced.
|
26
Head is being gutted .
|
27
Head emptied.Boards will all go out to be serviced.
|
28
Playfield teardown in process.
|
29
Underside teardown in process.
|
30
Switch harness hacked.
|
31
|
32
All wiring removed and separated.Will be gone through one harness at a time.
|
33
8 driver was cleaned and will be populated for the third magnet.
|
34
Third magnet hardware installed.
|
35
Switch harness is rebuilt.The hacked connector and wiring is removed.
|
36
A color correct section is properly wired in.I won't put the connector on it or cut it to length until I rebuild so I wi
|
37
Flippers will be rebuilt next.I am rebuilding this game as I tear it down to make it go a bit quicker at rebuild.
|
38
Nice.I am sure the flipper works great with the sleeve on the outside.
|
39
This is the pile of trash taken out of the flipper assemblies.
|
40
Flipper plates and parts are polished.The coils are new.
|