119
Final clear applied.
|
120
|
121
Inserts are finally level or at the very least smooth and easily transitioning as can be seen by the light reflections.
|
122
|
123
|
124
|
125
|
126
In about a week or so it will be more than ready for the final sand and buff.I will concentrate on other aspects of the res
|
127
Cabinet is ready to build.
|
128
Braided and up on new legs.
|
129
Coin door parts are back from plating.
|
130
|
131
new rails buttons etc installed.
|
132
New line filter,varistor and cord are made up and installed with added strain relief,
|
133
Plated and polished internal parts are being placed.
|
134
New plastic channel was made
|
135
Wiring has been spliced at the switch.
|
136
Cabinet flipper button switches are pretty beat.
|
137
Additionally the switch plate is rusted.
|
138
A new set of cabinet switches ,power switch and freshly plated switch plate will be installed.
|
139
New power switch and wiring are in place now one terminals and a molex connector to help clean up things without making
|
140
New flipper button switches are built and wired.Now also on plugs with new wiring and capacitors to eliminate arcing an
|
141
Head is now on the lower.
|
142
New labels were made for the interior of the head.The tin was cleaned up as well.
|
143
Will rework the lamp panel now.
|
144
Lamp panel is refinished.The wiring and connectors are gone through.
|
145
Lamp panel installed.
|
146
Wiring is put in place in the cabinet.
|
147
|
148
All wiring is neatly run any added connectors are tastefully placed or hidden so as not to detract from the original build
|
149
Tilt panel was refinished in white and rebuilt with polished parts.
|
150
Shameless plug for Ratchet.Also the other cleaned,polished or wired portions of the front of the cabinet.
Either white co
|
151
Supplied boards are in place.I am testing with the Rottendog solenoid driver but will be replacing thatr with the better
|
152
Now ready to build the coin door.These are very time consuming.Takes about 5 hours to build and wire one in the way that i
|
153
|
154
New skin is now in place.
|
155
New lamp sockets are used in addition to the numerous plated parts.Those not plated were blasted and or polished by hand
|
156
The door itself is built now I am making a new harness for it which is a bit tedious.All wiring is protected in key pl
|
157
New harness is extra long I will terminate it and install the proper plug once it is in place so I can make sure the len
|
158
I used Token plates on this door because I like the look of the black and red best for the cabinet colors.Cosmetic choice.
|