40
Switch harness.This one is worse off than it may look.Incorrect switches,hardware etc.I think all the targets and switched
|
41
Playfield is just about ready to come out.
|
42
Playfield is out and the topside it stripped complete.
|
43
Bottom is almost bare.
|
44
The sling looks to have been ripped out of the playfield at some point.
|
45
All the coils are junk as is most of the hardware that is holding them together.
|
46
A $5 bracket is welded instead of replaced.Hard to understand the logic in that but it will be replaced during the rebuild.
|
47
The wrong coil for this application.Will be replaced along with all the other coils.
|
48
Not sure what is going on here other than at some point the welds broke and they used the correct value coil but wrong bran
|
49
The weld seems solid and since this is a game specific or uncommon bracket I will just rework the weld to neaten it up and
|
50
This is the junk pile from the coil teardown.All this stuff is incorrect or just trash in general.The coils are beat.The fl
|
51
This is what is salvageable plus two new jet bumper brackets.The rest is either worth reusing or unreplaceable even
|
53
All the coil brackets have been cleaned,repaired,polished etc.
|
54
All new coils will be used.
|
55
All the coils are rebuilt.New sleeves and hardware.
|
56
The flipper assemblies are all new.Plates and hardware.The old ones were just to beaten and rigged to bother with.
|
57
|
58
The correct plungers were located and used on the up kicker assemblies.Prior to rebuild all wer inccorect or butchered.
|
59
Moving onto the mini playfield.
|
60
Teardown of the mini is in process.
|
61
|
62
The mechanical condition of the mini is equal to that of the lower.
|
63
Bigfoot will need a complete overhaul.
|
64
Bigfoot torn down
|
65
All parts cleaned and rebuilt including a bath for the bigfoot body and new NOS head.
|
66
Bigfoot is much improved.
|
67
The upper playfield flipper assembly will be replaced entirely.
|
68
New upper flipper compared to the old one.
|
69
The replacement upper playfield I am using has had an intital coat of clearcoat applied.This will seal it up so I can do th
|
70
The initial clean up and clearcoat has been applied to the lower playfield.It will need some rework but this is the firs
|
71
|
72
While I wait forthe playfield to cure I will get back to the cabinet clean up and restore.Starting withthe items already r
|
73
The panel has been cleaned and regrained.It is now ready to bag up and for use when we begin reassmbly.
|
74
The backbox lamp panel is very dirty.
|
75
The back side of it is equally dirty.
|
76
Most of the connectors are trashed.Some were the ones soldered directly to the boards.
|
77
The first step is to take it all the way apart.
|
78
It has been sanded front and back then refinished.
|
79
Ready to reassemble.All the metal parts were polished and the wiring was thoroughly washed and dried.
|
80
Panel reassmbled.Rear.
|