161
Matte clear applied.It is a little glossy right now because it was just applied but with dry down to a semi gloss type fini
|
162
The cabinet is finally ready for rebuild.
|
163
The lamp panel will need to be refreshed.It can only look so good in terms of grain since they just paint over a bar
|
164
Fresh white applied.
|
166
The head has been rebuilt including all new lamps and displays.One is missing because I just figured out I was one 6 digit
|
167
The lower rebuild is in process.New ground braid has been installed.
|
168
|
169
New siderails and all new nails are used.
|
170
I tore the tilt and chime assembly down and sanded the panel clean.
|
171
All the chimes were polished and rebuilt with new coils.
|
172
Tilt/Chime assembly ready to go back in the cabinet.A new polarized cord was also installed(part of this group of wiring b
|
173
Lower is at a point now where I can install the head.I went with white flipper button housings and straight red buttons(no
|
174
Head is back on.
|
176
|
177
|
178
|
179
|
180
In the front room now.will go up on legs next and get the rest of the cabinet parts installed.
|
181
I have a decent used skin to replace the crushed one on the game.I have watersanded it to make it look as new as possible.
|
182
The coindoor has been rebuilt and installed.The cabinet is back up on legs.
|
183
Cabinet rebuild is complete I am powering it up to test everything in that category before moving onto the playfield.
|
184
|
185
|
186
The worn playfield assembly is dropped back in the game for some quick testing before begining the teardown for the
|
187
|
188
the playfield has been pulled back out and now the playfield swap and component restore begins.
|
190
After sitting for about a year since I put the final clear on there is no doubt the replacement is fully cured.
|
191
|
192
Most of the top has been stripped off at this point.This is a good picture to show the transformation/process.
|
193
All the mechs will be completely rebuilt with new coils,hardware or upgrades whenever possible.The first step is alway
|
194
The mech is completely rebuilt with a new coil and an upgraded link.The other parts around it have been cleaned and po
|
195
the topside of the old playfield.Much of what is left in this picture will be replacd completely like the bumper assembli
|
196
The playfield siderails will each be stripped and refinished.I will use a color that matches the playfield and plast
|
197
The first siderail is refinished.
|
198
Refinished siderails installed on playfield
|
199
The old playfield is flipped over to begin the next phase.
|
200
The new playfield is ready to begin the underside rebuild.
|
201
New playfield has been t nutted.I am replacing EVERY single lamp socket and all the ground braid.That part is just getting
|
202
New sockets and braid are being run.They are being checked as I go with a meter to make sure they are poperly connected.Mu
|
203
The service outlet has been upgraded to a polarized grounded unit like the power cord.This allows you to plug in mode
|