161
Going to do the targets now.Here are the originals.
|
162
Cleaned polished and rebuilt with the new faces which is all you can get .
|
163
Same procedure with the tomb treasure target.Had a nice bracket etc for it as well.
|
164
Now for the auto lauch mech.
|
165
Most of it is junk.
|
166
Rebuilt with a new brachet and some of the other associated parts.
|
167
Now the trough.Part of the assembly isn't worth dealing with so that portion will be replaced.
|
168
Rebuilt trough.
|
169
|
170
|
171
Trough is in place now with the proper clearance of the modified flipper plate.
|
172
Ready to start running the switch harness.
|
173
Switch harness is placed.
|
174
Sling switches were rewired with thicker wire to eliminate the hassle of future breaks or shorts. .
|
175
Special attention was given to the diode as it can easily short between the blades if bent just right.That was place
|
176
Same details other side.
|
177
|
178
Wiring extended and protected in other key areas were potential catching or shorting could occur.
|
179
More protections and precautions as well as general neatening and improving of the harness and routing.
|
180
|
181
Now I will employ a similar method on the lamp harness.The biggest thing will be eliminating the generis and frail da
|
182
After a good bit of time I have this section done.I will continue until it is done all the way throughout the harness whe
|
183
|
184
The two holes pictured represent a small portion of the GI in the jet bumper section.The hole to the left of the screen
|
185
Daisy chain and socket fix now in place.
|
186
More rerouting and rewiring to neaten and protect the areas of the harness that could get compromised.
|
187
Finished the upper GI portions now I can move to the center and lower tomorrow.
|
188
Lower sections of GI now reworked with the thicker,correct color wire.Run in ways that keep things neat and orderly.
|
189
|
190
|
191
Flasher sockets are redone where needed as well.
|
193
Forgot to mention during the switch harness run that all crimp on connectors were removed in favor of direct soldering
|
194
Wiriing is basically done or at least as far as it goes outside of the cabinet.
|
195
|
196
|
197
|
198
Ready to install in the cabinet now.
|
199
Playfield is now in the cabinet.
|
200
|
201
Apron is installed along with many of the new plastics.
|