1
This is one of the roughest WH2Os I have seen.
The cabinet is well faded but overall solid.
|
2
Homemade shooter rod :-)
|
3
|
4
Rear is not chewed up.
|
5
There is an extra hole in there.Probably from a counter or some type of security device.
|
6
At a glance it doesn't look so terrible but...
|
7
Pretty dirty.
|
8
Most of the ramps are broken.
|
9
LOTS of corrosion.
|
10
The sling plastics are just clear cut outs with decals applied to the backside.It will need a new plastic set anyway.
|
11
The targets are incorrect.
|
12
Shooter lane might sand up clean.
|
13
Wood putty was smeared in the upper playfield.It is proabably has a big divot in it and was trapping the ball.The reast of
|
14
The condition of the boards and wiring in the head is rough.
|
15
Lots of hacked connectors and some have been soldered straight to the board itself.
|
16
Not sure why they were cuttin and taping so much in here.There will be a lot of effort put into getting the wiring straight
|
17
Underneath is as bad as the inside of the head.Lots of corrosion and hacks.
|
18
Incorrect brackets,welded $5 parts,more electrical tape and lose/free wires.
|
19
Some of the free wires have masking tape on them.Not sure what they were trying to mark or how half of the lights would wor
|
20
The flipper assemblies are BEAT.Doubt the game was very fun or playable in this condition.
|
21
More tape,butt connectors and of course corrosion :-(
|
22
Broken brackets,incorrect coils and zip ties holding that whole package together.
|
23
Inside the cab is more of the same.Corrosion,rust,hacks,tape etc.
|
24
More wood putty.This time it is smeared on the inner chocks.These will just be replaced during the cabinet restore.
|
25
Teardown is underway.
|
26
Some of the wiring is soldered direct to the boards(not supposed to be) so it will have to be cut free in order to get the
|
27
|
27
All the boards are out of the head.
|
28
Most of the boards are hacked or have issues.I have cleaned them up to fully evaluate the status.The Driver,Fliptronic,CPU
|
29
The driver is in need of some wrk.Beyond the typical GI issues it has some jumpers etc.
|
30
Poor work done on the CPU.A chip was reworked but given the state of the rest of the game I don't trust it.
|
31
Jumper on the waterfal lamp driver.
|
32
Back to teardown.The ramps and boulders are removed.
|
33
Instead of having the correct plastic stand offs this game has cut up rubber post doing that job.That will be taken care of
|
34
Never seen this before but both sling arms are missing the plastics.
|
35
Back to teardown.
|
36
Coils and coil harness removed.
|
37
All harnesses are renoved as well as most parts underneath.
|
38
ALL the harnesses will need lots of workPictured is the coil harness.
|
39
Lamp harness.Of all thisone needs the least attention.
|