202
|
203
|
204
New flipper button switches were used with a capacitor to eliminate sparking and a plug for easy servicing.
|
205
|
205a
Apron is sanded and ready to base in red then clear.
|
205b
Apron is based and cleared.The clear is wet and glossy at this point but once dry it will be more of a semi gloss t
|
206
This bundle of wires is what keeps me from separating the upper playfield from the lower easily so I will create a ju
|
207
There are nearly 80 wires I believe so I am going to group them by size and function.Each will be metered out to
|
208
Several hours later here we are.Each plug is different and the two that are the same are keyed so they cannot be plu
|
209
A smaller junction was needed on the other side.There will be a plug or two needed at the end of the build to finish
|
210
|
211
Prepping the new lower for build up.
|
212
All new sockets and braid will be run.Screw terminals are used for each socket to make lamp servicing easy in the f
|
213
Braid is run.
|
214
Few parts are placed topside prior to wiring the underside.
|
215
All post are new.
|
216
|
217
|
218
New stand up targets are installed.
|
219
|
220
The harness is removed from the old playfield and cleaned.Thre is a lot of work to be done and things to be replaced/r
|
221
All dedicated lamp sockets will be replaced.
|
222
Lamp sockets are replaced.
|
223
|
224
Switches are cleaned and gapped.The caps are also replaced and put through protective tubing to eliminate shorting.
|
225
New targets are rebuilt in the same manner.
|
226
All coil assemblies are rebuilt and the metal is polished.New wrappers would be nice but given the masking tape type ma
|
227
|
228
Flippers are rebuilt with new coils and kits from the previous generation of games so they will preform a bit bette
|
229
|
230
Other metal parts are polished.All screws are new.
|
231
Lower playfield wiring is just about complete.
|
232
Main playfield is resting in the cabinet.I will do the upper next then rejoin them and the game will be just about c
|
233
The upper playfield is sanded and ready to polish.I did not reclear it because as they arrive there is already too much
|
234
A very thin file is being used to open the insert rollovers back up.Some are so thick that the file will not go in
|
235
|
236
Several hours later all insert roll overs are corrected and will now work properly during game play without the threat
|
237
I can now start the upper playfield swap.
|
238
The effort put into separating the upper and lower was pretty enormous at the time with the plus and keying of evertyt
|
239
All upper playfield switches are cleaned and new capacitors are installed through protective sleeving.
|